I am using Rad Studio 10.2.3 (C++ Builder) and I cannot run my application with this new version.
If I create a new Intraweb project it works.
But with the old one, the first error message was below:
1. [Fatal Error] The name BCC_OptimizeForSpeed. contains an invalid character ".".
I had to open the project file manually and remove that character. But I have been compiling and running that project for years!
After that, I am getting that error message now:
2. [Fatal Error] Access violation at address 5005A7AB in module 'rtl250.bpl'. Read of address 57D09A44
I think you need to rebuild the new 15.3.6 version with Rad Studio 10.2.3! Because for sure there is something wrong!
Finally, I was able to have my old application compile and run!
But I think it will be a good thing to test this new version on your side with some old C++ Builder 10.2.3 to see if they can be compiled and linked with no problem!
If I create a new Intraweb project it works.
But with the old one, the first error message was below:
1. [Fatal Error] The name BCC_OptimizeForSpeed. contains an invalid character ".".
I had to open the project file manually and remove that character. But I have been compiling and running that project for years!
After that, I am getting that error message now:
2. [Fatal Error] Access violation at address 5005A7AB in module 'rtl250.bpl'. Read of address 57D09A44
I think you need to rebuild the new 15.3.6 version with Rad Studio 10.2.3! Because for sure there is something wrong!
Finally, I was able to have my old application compile and run!
But I think it will be a good thing to test this new version on your side with some old C++ Builder 10.2.3 to see if they can be compiled and linked with no problem!